Jump to content

Windows 10 Start up? The handle is invalid. Fix or Update?


Jim Applebaugh

Recommended Posts

Jim Applebaugh
I see other posts about the missing "run at startup" with no answers. I've wasted a lot of time with trying to get this to start up on windows 10. Run synergy... ERROR: failed to launch, error: The handle is invalid. Run synergys/synergyc I get a big log window that I can't close with out closing the program. Older versions run just fine. I paid $10 to have updated versions but... they don't seem to work.
Link to comment
Share on other sites

I have the synergy application running on windows 10 without any problems. When are you recieving this error? I am running version 1.7.5 and it does not really create that much of an issue. Is this the first time you run it?
Link to comment
Share on other sites

Jim Applebaugh
Yup 1.7.5 on 3 different computers. They all give the same error if started by the launcher (synergy.exe). Just see the error scrolling by over & over again. Never fully starts. Starting either server or client from the command line gives me a cmd window box that shows the error log. Closing it closes synergy. Example startup: (/min is to at least minimize the stupid thing log window) START /min C:\MyStuff\MyApps\Synergy\synergys.exe --debug FATAL --config C:\MyStuff\MyApps\Synergy\ConfigMain.sgc As a side note I noticed if I'm running a game such as Everquest all mouse clicks, click on both client & server. The old version didn't do this but was wildly erratic on mouse speeds in a game window on a client.
Link to comment
Share on other sites

I am not 100% sure but this sounds a bit like a configuration that has gone bogus. As mentioned I have 2 win machines and 1 mac. None of them show this kind of behaviour you are mentioning. Maybe you could try to uninstall the application, clear all the old configurations (back them up) and then try a fresh setup. Starting with Server install and then only configure one client at the time? Sorry if I am not much help but I start the application from the .exe using the GUI not from the commandline.
Link to comment
Share on other sites

Jim Applebaugh
I uninstalled it a number of times. Started from scratch too. I messed with it for a couple day. Synergy has always been my go to software KVM for years now but I can't get it to work & the paid for update was worse so... yeah. Trying other software now.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...